ICCD SMARTCARD DRIVER DOWNLOAD

It may return less. All messages transmitted over bulk endpoints start with a 10 byte-header, optionally followed by data. P3 INS parameter of a command header. The value is given in units of 10ms e. The sequence starts with the ICC powered off. Used interchangeably with Smart Card.

Uploader: Fenrikus
Date Added: 1 March 2014
File Size: 11.50 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 92330
Price: Free* [*Free Regsitration Required]

The following tables give the values and the parameters for each of the class specific smaetcard and describe the data that is transferred between host and USB-ICC. For control transfers two implementations are possible version A and version B.

NOTE The first condition allows the host to detect an unresponsive card.

BIFIT BIFIT ICCD Smart Card Reader how to download and install the driver

For the parameters, the following general rules shall apply: In order to save bandwidth, the time interval should not be less than 10ms. In addition, sequence numbering assigns command messages with their corresponding response messages. Control transfer mode is supported by two versions, version A and version B.

The response APDU begins with this command and is to continue 02h: The following clauses give the values and the parameters for each of the class specific requests and describe the data that is transferred between host and USB-ICC. If wDelayTime equals h, the host shall set the polling interval at its own discretion.

  DCR-TRV33E PAL DRIVER DOWNLOAD

Returns the ATR in the data stage. The period, which is considered as time-out, is driver dependent and should not be less than 1 second.

This address is an endpoint number between 1 and These requests provide smarctard same services to the application layer as bulk transfers.

All messages transmitted over bulk endpoints start with a 10 byte-header, optionally followed by data. Zero-based value identifying the index in the array of concurrent interfaces supported by this configuration. Used interchangeably with Smart Card. Smarrcard the abData field contains the delay time wDelayTime until the host waits to send out the next request.

README · master · Ludovic Rousseau / CCID · GitLab

Smagtcard USB connection device is out of the scope of this specification. The wValue field specifies bLevelParameter in the high byte and bReserved in the low byte.

USB electrical interface and operating procedures 1. The sequence starts with the ICC powered off. Alternate settings are not supported. Its size is 0, 1, 2, or 3 bytes. The host may abort any transfer by sending an IN-token prematurely.

  DELL E6440 WIRELESS DRIVER

It may have the values in Table 6. The following two tables give the values for the status and the error codes.

For the correct transmission of data, the following general rules shall apply: The maximum number of bytes expected in the data field of the response APDU.

Instead, it uses class-specific protocols on the interface level.

CCID (protocol)

Size of expected data to be returned by the bulk-IN endpoint. It’s a community-based project which helps to repair anything. The recommended value is In case of a failure, an error code will be returned. The response APDU begins and ends smadtcard this command 01h:

Author: admin